burning loss
英 [ˈbɜːnɪŋ lɒs]
美 [ˈbɜːrnɪŋ lɔːs]
网络 烧失量
双语例句
- Some solutions are put forward by analyzing reasons of burning loss for the screwdown screw and nut on steckel mill.
通过对炉卷轧机的压下螺丝与螺母烧损的设备事故现象的分析，找出事故产生的原因，并提出了相应的解决方案。 - The problems of water leaking and burning loss on feeding and output hanging arm rolls in rod heating furnace are analyzed, some measures proposed.
对宣钢棒材加热炉出入炉悬臂辊道漏水、烧损等现象进行了分析，提出了改进措施。 - Finally, some corresponding countermeasures are given for the burning loss of split-phase.
对各种情况下的分相烧伤问题提出了具有针对性的防治措施。 - Reason analysis of bush burning loss fault of steam-driven feed pump in 600 MW unit and countermeasure
600MW机组汽动给水泵烧瓦原因分析及对策 - The Factors of CDQ Device Burning Loss Rate and the Boiler Steam Production
影响干熄焦装置烧损率、锅炉产汽量的因素探析 - The Burning Loss Analysis of the Insulating Parallel Groove Clamps of JBL series& Measures for Improvement
JBL系列绝缘并沟线夹烧损分析及改进措施 - Experimental study on lance burning loss during powder injection for hot metal dephosphorization Slagging characteristics on refractory materials during pulverized-coal combusting
铁水喷粉脱磷用耐火材料烧损的实验研究基于耐火材料的粉煤燃烧过程结渣特性 - By increasing the weld heat input, the distribution of martensite becomes more dispersive and glomerate due to the molten pool stiring, the welding stress and the burning loss of alloy elements.
随着焊接热输入量的增加，由于熔池搅拌、焊接应力、合金元素烧损等原因，马氏体的分布更加散乱和密集； - This paper analyzes and summarizes the causes of burning loss of magnetic clutch for automotive air-conditioning compressor, advances the corresponding protective measures.
分析和归纳汽车空调压缩机电磁离合器烧损原因，并提出相应的预防措施。 - Discussion on the Burning Loss of secondary Wind Pipe of Pellet Firing Furnace
球团焙烧炉二次风管烧损原因分析 - Technical Analysis of Severe Oxidizing Burning Loss of Heating Furnace
加热炉氧化烧损严重的技术分析 - The discussion to reduce steel billet oxidation burning loss
减少钢坯氧化烧损的探讨 - Carbon Burning Loss of Calcining DG Petroleum Coke in Pot Furnace
罐式炉煅烧DG石油焦的碳质烧损 - As heating die sleeve, a few grain charcoal is added and oxygen is consumed by charcoal burning so that oxidation burning loss is reduced.
在加热模套时，可放入少量颗粒木炭，通过木炭的燃烧消耗氧气达到减少氧化烧损的目的。 - How to reduce the burning loss rate of forge piece
如何降低锻件的烧损率 - During preparation, advanced argon protection technique and new flux covering technique were used to prevent burning loss of lithium.
在制备过程中，采用了先进的氩气保护、新型熔剂覆盖技术防止锂元素的烧损； - The blinding and burning loss of the honeycomb ceramics are usually observed during the service process, which affect the normal heat supply of the furnace.
蜂窝体在使用过程中常出现堵塞、烧损等现象，影响炉内正常供热，分析认为是由于煤气中粉尘过多和蓄热体结构不合理所致。 - Moreover, this paper enumerates the achieved comprehensive results of energy conservation, reducing consumption, reducing burning loss, increasing the yield of products and improving the quality of products after the measures have been applied to the production.
此外，本文也列举了这种解决办法应用于生产后所达到的节能、降耗、降烧损、提高产品产量和质量的综合效果。 - In order to overcome superheating and burning loss of rolling bearings, several methods of selecting rolling bearing fit are discussed, and on the basis of practice experience, the proposal on selecting fit is put forward.
为克服滚动轴承的过热和烧损，本文比较并讨论了轴承配合选择的几种方法，并依据工作实践给出了选择配合的建议。 - As a result, the heating capacity and quality of heating furnace is improved, the slab surface oxidation burning loss is decreased and the gas consumption reduced and the economic benefit remarkable.
改造后使加热炉提高了加热能力和加热质量，减少了板坯表面氧化烧损，降低了煤气消耗，经济效益显著。 - The effects of air flow, temperature, total catalyst concentration, [ Co]/ [ Mn] ratio, bromide concentration, water content on the catalytic burning loss rate of acetic acid are discussed.
分别考察了空气流量、温度、催化剂总浓度、[Co]/[Mn]比、溴离子浓度、水含量等因素对醋酸燃烧损失速率的影响。 - Heating time is shortened, oxidation burning loss is reduced, and production efficiency is raised when temperature is 1 000 ℃.
加热温度在1000℃时，可有效缩短加热时间、减少氧化烧损、提高生产效率； - Prevention of burning loss of carbon reductant in pellets during rotary kiln preparation of phosphoric acid
窑法磷酸工艺中球团内碳还原剂烧损的抑制 - Due to the burning loss of Ti, deleterious graphite phases form during solidification.
由于Ti元素的烧损，生成了有害相石墨。 - Reasons of oxidation burning loss to heating furnace and its countermeasures
加热炉氧化烧损原因与对策分析 - The phenomenon of blade distributor disk burning is one of the common faults of the vane pump. In this paper, the causes of distributor disk burning loss of blade is analyzed, and measurement by using the theory of dynamic pressure alignment is discussed.
烧盘现象是叶片泵常见故障，通过分析产生烧盘现象的原因，探讨动压扶中理论应用于叶片泵解决烧盘现象的前景。 - The flue gas heat loss, heat emission loss and non-full burning loss are the main loss of the steam-injection boiler.
注汽锅炉的热损失主要为：排烟热损失、散热热损失和化学不完全燃烧热损失。 - Therefore, the carbonization furnace with external heating is designed, and it has the advantages of fast carbonization, avoid of burning loss and autothermal process.
为此，本项目研究自行设计了外热式快速炭化炉，具有快速炭化、炭化过程中避免半焦烧损、过程自热的优点。 - After the parameter optimization, the burning loss and evaporation of Mg element in the weld zone reduced.
参数优化后焊缝区Mg元素的烧损和蒸发量减少。